- Sat May 14, 2022 10:45 am
#56943
Hello, i have pazi88 rev2.0 board for my m50b25 non vanos.
I retrofited vanos to it but i cant get it work..
Pazi88 told me to take +12v from injector (ign on) to vanos solenoid, and from ecu pin number 7 to vanos solenoid.
Also i had to solder a jumper to JP30.
I did this all and i selected pin7 from settings and turned on the vanos, i measured with voltage meter from vanos solenoid plug and there comes only 1volt.
I have double checked all the wiring and they are ok.
Is there some other jumper or something that i have to solder?
Thanks!
I retrofited vanos to it but i cant get it work..
Pazi88 told me to take +12v from injector (ign on) to vanos solenoid, and from ecu pin number 7 to vanos solenoid.
Also i had to solder a jumper to JP30.
I did this all and i selected pin7 from settings and turned on the vanos, i measured with voltage meter from vanos solenoid plug and there comes only 1volt.
I have double checked all the wiring and they are ok.
Is there some other jumper or something that i have to solder?
Thanks!