For any discussion not specifically related to your project
By roger.rrgt
#51978
I am having this exact issue. Using a VW 037906433A hall sensor on a 60-2 tooth wheel with no cam sensor. This sensor grounds when the teeth is over and when the engine is working ( carburetor and etc) i can read 2.55V with a multimeter, so i guess it is switching on and off as it should.
The board is a 4.3c and all the jumpers are on hall and pull up.

Hi, I am trying to assign Signed values to the x-a[…]

Vr Conditioner Noise when cranking

New version 202305 don't fix the issue. Now after[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Hello, I bring news!! Let me tell you that after […]

Still can't find what you're looking for?