For any discussion not specifically related to your project
#48892
plazomat wrote: Tue Mar 09, 2021 4:39 pm Can't seem to find this..but is there anyway to display the measured value of the NB O2 sensor in tuner studio?

Could do this with MS2 was wondering if I am missing something with Speedy?

Plaz

YES

Go into an inc file and set it to have both columns the same 0v to 1v. Then set a a gauge to read the same range. You now have a 0v to 1v gauge that reads the NB o2 or any range you choose.

You can have this read into IAT or MAP BARROW if you don't want to remove the O2 that runs your tune.

Good luck.

I did this and it was fun and I learned a lot from it.

Black Knight
#48903
plazomat wrote: Wed Mar 10, 2021 3:03 am Thanks Black Night,

Glad to hear this is possible - would you be able to point me to the inc file?

Plaz
You are welcome.

There are two places that will work for you.

O2 has an inc file on the page you do the calibration called custom inc file for this reason.

If you need to keep the O2 working for logging during your journey with this, use IAT custom inc file.
There are many custom inc files for O2 that are there to set the calibration for various vendors of O2 sensor kits.

You will need an editor that will work with inc files.

You can view these files with most editors but not change them.


Have fun

Black Knight

I think I know why you are doing this.

Later

I uploaded logs and last tune and dyno plots look[…]

you could set 'skip revolutions' to 3, then it wou[…]

Hi, I am trying to assign Signed values to the x-a[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Still can't find what you're looking for?