Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any discussion not specifically related to your project
By plazomat
#46812
Hi,

Finally got car running using MS and basic distributor as a proof of successful wiring. Now ready to get it going on a custom speedy with crank trigger..

A while ago I remember seeing a wheel design/ calculator around here that was easy to design your own wheel and order one from them.

I can't seem to find it now that I am ready to purchase a wheel. Are they still around? Or alternatively does anyone know of an economical place to get?

I need about a 7.5 inch wheel, 36-1 - small block mopar crank application. Also any diy friendly hall sensor suggestions would be welcomed.

Thanks in advance for any help.
Plaz
CLT sensor wrong reading

Thx for quick response, ill check it other day ;[…]

Hi, the original Novitec controller was much more […]

What knock sensor are you using? The stock […]

Another type1 Beetle motor

If you have crossbar linkage, you'll need a shorte[…]

Still can't find what you're looking for?