Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any discussion not specifically related to your project
By Gregtsi88
#46657
Having issues getting crank signal we are running a ua4c using a 98 ford escort crank sensor i have the air gap at about 25k No sinc what so ever through tuner studio. But then my buddy touched the vr board by accident and we had sync for a second. And we do have the jp2 going in direct with no pull up resistor
By hotrodandy
#46658
Ok so we swapped it over to a hall effect sensor, one from diy auto tune that I had "the black one". I changed the jumper jp2 to direct. When I use my scope it shows a nice square wave when I hook it up to rpm1+ my signal goes away. Any ideas?
Messing with Subaru 6/7 trigger

Hi, Ive been trying to work on the 6/7 trigger wh[…]

Great info here! thats good to work with 0.4 type […]

Anomaly lamp

Hello, I'm new to speeduino. Would it be possible […]

Real Dash on Teensy 4.1 - Serial 2

Thanks for the release, the information is new for[…]

Still can't find what you're looking for?