- Mon Jul 27, 2020 5:56 pm
#44464
Hello people
I'm using the ardustim to simulate the crank together with the 0.4.3c board. However, the rpm in the tunerstudio reaches a maximum of 1500 if I set a higher rpm, the rpm pointer returns to zero and the injection and ignition leds stop flashing.
But when I do the simulation using only the arduino mega without the board with the crank connected directly to the digital 19 this problem does not occur.
Thank you
I'm using the ardustim to simulate the crank together with the 0.4.3c board. However, the rpm in the tunerstudio reaches a maximum of 1500 if I set a higher rpm, the rpm pointer returns to zero and the injection and ignition leds stop flashing.
But when I do the simulation using only the arduino mega without the board with the crank connected directly to the digital 19 this problem does not occur.
Thank you