[Dalenutbrown]

This may be more of a tunerstudio question, or maybe specific to speeduino.
I am running a 3.6 speeduino and running without afr correction.. I have been building a pi dash to replace my gauges.
I have an afr gauge setup but want to add an additional gauge that will show target afr - measured afr. I think that would be ego correction but do not know if that will be a calculated value or a value calculated by what speedy would do if it was running afr correction.
If it is not can a gauge be created that just uses a calculation string such as target afr-afr?
Thanks
Dale

[PSIG]

… I think that would be ego correction …

That's it, Dale. I use EGO_Corr as a % deviation whether it's actually correcting or not. Does that suit your goals? Alternatively, you can set-up comparative reference gauges such as this, for one idea.

David

EGO_Corr_gauge.png (18.31 KiB) Viewed 2787 times

[Dalenutbrown]

That is exactly what I needed to know thank you. I had it set up with one dial and two needles but was a bit confusing.
I have the bar gauges as you show setup but fuel pressure under the afr so they would be equal at full boost.
Thanks again.
Dale