Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
Help with building your Speeduino, installing it, getting it to run etc.
User avatar
By speeduino-v6
#57298
Hello, Im tryring to get a v6 60Degrees engine ignition to run on a speeduino 0.3.7. But im not getting any spark of my wasted spark coil. When i am testing te outputs of the speeduino it give 5Vdc and the wasted sparkt coil fire by turning the 5V off. Im using
only the original distributor with a 6-1 wheel that gives a 12v puls on rpm1 . When cranking the rpm goes up in tunerstudio.
The engine fuels is regulated with an carburator.

Wasted spark coil
Febi 078 905 104 a
jumper setting
jp1 5v
jp2 vr conditioner
jp3 vr conditioner
jp4 off
jp5 off
Attachments
(638.51 KiB) Downloaded 24 times
PCB for BMW m52 engine

I had a Speeduino MS41 REV3.0B made by JLC PCB a[…]

540HP NA 7L V12 3Seater

That looks like an interesting worm hole. I can't […]

I would like to get an eagle and swap in a stroked[…]

Oh man! I am getting consistent RPM! That's […]

Still can't find what you're looking for?