Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
Help with building your Speeduino, installing it, getting it to run etc.
User avatar
By speeduino-v6
#57298
Hello, Im tryring to get a v6 60Degrees engine ignition to run on a speeduino 0.3.7. But im not getting any spark of my wasted spark coil. When i am testing te outputs of the speeduino it give 5Vdc and the wasted sparkt coil fire by turning the 5V off. Im using
only the original distributor with a 6-1 wheel that gives a 12v puls on rpm1 . When cranking the rpm goes up in tunerstudio.
The engine fuels is regulated with an carburator.

Wasted spark coil
Febi 078 905 104 a
jumper setting
jp1 5v
jp2 vr conditioner
jp3 vr conditioner
jp4 off
jp5 off
Attachments
(638.51 KiB) Downloaded 17 times
Sync loss on gsxr

Hi Good summer! I am still fighting this problem […]

My bad, happens on hybrid bikes. ST2 has an in tan[…]

Apologies for the tardy response. Been busy with o[…]

ca20e help

the orange screw terminal, in the bottom left corn[…]

Still can't find what you're looking for?