- Sat Jul 24, 2021 2:47 pm
#51997
After some time searching and scratching my head, i thought it was time to make my own post. My project is to replace the carburetor and distributor in a original engine, ok.. The vehicle is a trycicle, rear suspension and engine from a brasilia and a long front suspension. For the parts, they are coming from a hyosung gt250 motorcycle, because why not? These parts came to me for free and nothing beat free parts! Is has two 28mm throttle bodies, wich might be fine, my goal is not performance, and only 2 injectors. The trigger wheel came from something rusty and is a 60-2, the sensor is a VW hall 037906433a (this was bought new ). Now the problem, got this sensor working fine with the pull up resistor, but the 5V signal dont reach the arduino pin D19. I can measure the 5V in the middle pin of jp2 without the jumper on it, and when set to hall, i have nothing, my bet is at the c25 as mine has a little dent on it, how does a ceramic capacitor dies only testing the sensor? how can i test it? I will be providing a replacement this week and come back to tell if he was the culprit.
Attachments
IMG_20210724_110443724.jpg (1.25 MiB) Viewed 6141 times
IMG_20210721_113849581_HDR.jpg (525.82 KiB) Viewed 6141 times