Help with building your Speeduino, installing it, getting it to run etc.
By neovin
#52516
According to that tune file the injector size is set to 0.0, try setting them again
By LPG2CV
#52517
Hi there

There are mathematical operators at the top of the screen :)

save your tune first, or perhaps export the table (green arrows, also at the top of the screen) :D
By tigerstyle
#52522
LPG2CV wrote: Sun Aug 15, 2021 6:20 am
There are mathematical operators at the top of the screen :)
Nice thanks!
I had my original question a bit wrong, I want to half the required fuel and double the VE to get my low VE numbers higher :)
By neovin
#53022
Just going back through conversations.
If you are using a 0.4.3 speeduino with the pressure sensor supplied (mpx4250) your calibration is way off
MAP LOOKUP & TS DEFINITIONS

See how the write commands use the identifiers to […]

Ok, I feel so stupid. I was running the Uno output[…]

Let's all have a laugh for second. There's trash[…]

It has been done more than a few times, there was […]

Still can't find what you're looking for?