- Sun Jun 06, 2021 8:43 am
#50876
Hi,
I started a speedy project on e30 m40b16
im having some sync losses occationally
Crank Sensor is ZF GS100502
with Timing light trigger angle - 243
i tried running with Rising edge and Falling edge even when synced with timing light
with falling edge tooth logger doesnt look right with rising edge it looks correctly as it should
any help would be appriciated
Tune. tooth logger (both rising edge and falling edge) and a datalog attached
PCB Used - http://speeduino.com/forum/viewtopic.ph ... 78ab053489
I started a speedy project on e30 m40b16
im having some sync losses occationally
Crank Sensor is ZF GS100502
with Timing light trigger angle - 243
i tried running with Rising edge and Falling edge even when synced with timing light
with falling edge tooth logger doesnt look right with rising edge it looks correctly as it should
any help would be appriciated
Tune. tooth logger (both rising edge and falling edge) and a datalog attached
PCB Used - http://speeduino.com/forum/viewtopic.ph ... 78ab053489
Attachments
(1.8 MiB) Downloaded 137 times
(231.4 KiB) Downloaded 126 times
(20.83 KiB) Downloaded 134 times
(112.19 KiB) Downloaded 134 times
(26.38 KiB) Downloaded 130 times