- Sat May 08, 2021 6:40 am
#50156
Hello guys and galls!
Running into some issues with my UA4C with 202103 firmware and trying to figure out if I messed up. (probably)
Using direct ignition coils from Granatelli which are a drop in replacement for Ford Ecoboost 2.0/2.3 (2012 Focus/RS) 3 pins: 12V, ground and trigger, I put 12V and ground on them and when hitting the trigger pin with a 5V I get a spark so I setup Spark Output triggers to Going High.
Started out with wasted spark and got a spark when cranking, changed to sequential (still got sync in TS so both crank and cam sensors are working) and no spark, after a while coils got pretty hot ~50C so checked some stuff and the 5V ignition signal stays high after first cranking. (was low before starting cranking)
Running into some issues with my UA4C with 202103 firmware and trying to figure out if I messed up. (probably)
Using direct ignition coils from Granatelli which are a drop in replacement for Ford Ecoboost 2.0/2.3 (2012 Focus/RS) 3 pins: 12V, ground and trigger, I put 12V and ground on them and when hitting the trigger pin with a 5V I get a spark so I setup Spark Output triggers to Going High.
Started out with wasted spark and got a spark when cranking, changed to sequential (still got sync in TS so both crank and cam sensors are working) and no spark, after a while coils got pretty hot ~50C so checked some stuff and the 5V ignition signal stays high after first cranking. (was low before starting cranking)