[MattMatt]

This is probably a basic dumb question but I just need to be reassured.
I’m wiring up my RV8 with V4 board and just checking the injector pins. I assume that Inj 1 pin 1 goes to cyl 1 and inj1 pin 2 can go to cyl 6, inj2 pin1 goes to cyl 8 and pin 2 to cyl 5 etc etc. But, can I also use pin 1 for both cyl 1 and 6, 8 and 5 etc without any problems?

[jonbill]

Yes, I think the intention is that both pins are used for all cylinders on that channel.