Help with building your Speeduino, installing it, getting it to run etc.
By MattMatt
#50139
This is probably a basic dumb question but I just need to be reassured.
I’m wiring up my RV8 with V4 board and just checking the injector pins. I assume that Inj 1 pin 1 goes to cyl 1 and inj1 pin 2 can go to cyl 6, inj2 pin1 goes to cyl 8 and pin 2 to cyl 5 etc etc. But, can I also use pin 1 for both cyl 1 and 6, 8 and 5 etc without any problems?

I think possible reasons for that would be: 1) loo[…]

It looks like you have a fuel supply issue. readin[…]

Will this have an updated version about this featu[…]

Perhaps some different points and pictures. Instr[…]

Still can't find what you're looking for?