Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
Help with building your Speeduino, installing it, getting it to run etc.
How i can see with tunerstudio the signal from cam sensor ? Because when i am looking the composite logger when cranking i see the signal from crank sensor in blue color , the red line from sync but that green from the cam signal doesnt appear at all. And so on i dont have a spark either...
theonewithin wrote:
Thu May 06, 2021 9:35 pm
Do you have a can sensor connected that is support?

You haven't posted your tune or a log either. Both are needed to see what is happening.

Also have you read the wiki to get an understanding of what signals the ECU requires to run?
Give me mail address or messenger to post some pictures of the project , because here is a little hard to me to send to you

looks the same as the VAG coil, they don't need a […]

your idle advance is working harder from about 44 […]

mx5 PNP coolant fan control

Changes to the wiki can be done by anyone who requ[…]

Jaguar V12 second edition

Did you know this? :oops: I have use a 4 pin G[…]

Still can't find what you're looking for?