- Sun Apr 04, 2021 3:49 pm
#49466
Hi everyone, i bought an Speeduino v0.4 board from Spark EMS in Turkey. I made the connections by looking at the documents of my vehicle's old ecus, everything works but it does not see the crank sensor. My vehicle was Opel omega X20XEV old ecu simtech 56.01. I think the crank sensor I just bought is the hall but I'm not sure. I connected the 1st pin of the crank sensor to 5v, the second pin to 25 on the speeduino, the third pin to the gnd. I've tried a few other different combinations but it just didn't work. I have different sensors but not worked. The LEDs on my card were lightning strongly, but now it started to light weakly. Were the sensors I use VR? Could I have fried the board?