- Sun Nov 01, 2020 1:52 pm
#46132
I have a 750cc 3 cylinder water cooled 2 stroke I would like to EFI.
I have seen a couple of posts on 2 stroke work (TZ350?) but cant find much detail.
I have some Arduino experience and wondered if anyone had a working system? Guidance?
While I would like to do fuel and ignition I am happy to start with fuel first....I think that will be a big enough challenge
I believe the sensor suite I need is;
TPS sensor to run Alpha-N (no MAP sensor).
IAT (Inlet Air Temperature).
CLT (Coolant Temperature)
MAF (mass air flow)
Wideband O2 sensor and controller (optional), to check for optimal combustion. Oil will be an issue.....
Rev counter
Crank sensor
Thanks
Kev
I have seen a couple of posts on 2 stroke work (TZ350?) but cant find much detail.
I have some Arduino experience and wondered if anyone had a working system? Guidance?
While I would like to do fuel and ignition I am happy to start with fuel first....I think that will be a big enough challenge
I believe the sensor suite I need is;
TPS sensor to run Alpha-N (no MAP sensor).
IAT (Inlet Air Temperature).
CLT (Coolant Temperature)
MAF (mass air flow)
Wideband O2 sensor and controller (optional), to check for optimal combustion. Oil will be an issue.....
Rev counter
Crank sensor
Thanks
Kev