Help with building your Speeduino, installing it, getting it to run etc.
By dzozepe
#45758
Hello guys i have a problem and im not good electrician. My arudino is not getting power and i measured voltage regulator but there is no 12V going to LM2940T. Also measured 2N2222 transistor which is supposed to trigger ground when ignition switch(base) is on and there is 12V going on emitor and collector. Could you help please? because Im lost.

At the beginning it was working but i shortened IGBTs with passive aluminium cooler(my bad) then replaced and suddenly no arduino power. Here is link to full schematic of the board.

https://easyeda.com/editor#id=e5528dac3 ... 7456e4c3c4

It looks like you have a fuel supply issue. readin[…]

Will this have an updated version about this featu[…]

Vr Conditioner Noise when cranking

I did the fix, but it's not work. I put my setti[…]

Perhaps some different points and pictures. Instr[…]

Still can't find what you're looking for?