Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
Help with building your Speeduino, installing it, getting it to run etc.
By dzozepe
#45758
Hello guys i have a problem and im not good electrician. My arudino is not getting power and i measured voltage regulator but there is no 12V going to LM2940T. Also measured 2N2222 transistor which is supposed to trigger ground when ignition switch(base) is on and there is 12V going on emitor and collector. Could you help please? because Im lost.

At the beginning it was working but i shortened IGBTs with passive aluminium cooler(my bad) then replaced and suddenly no arduino power. Here is link to full schematic of the board.

https://easyeda.com/editor#id=e5528dac3 ... 7456e4c3c4
Jaguar V12 second edition

I believe more and more on a software issue. Speed[…]

You should be able to use PWM using the VVT tabl[…]

retroject flooding

sounds like you might have some pin misconfigurati[…]

As above. Check the schematic whenever you are uns[…]

Still can't find what you're looking for?