- Mon Apr 06, 2020 5:29 pm
#41880
I have assembled my speeduino board. downloaded all the software and uploaded it to the speeduino. I've got an arduino uno with ardustim thats set to 36-1 at 750 rpm, speeduino has base map that trigger settings at 36-1. The speeduino rpm gauge doesn't show anything. The speeduion has lights LED 5 and LED 7 on permanently with no change. 12v source is plugged in and gnd taken to uno.
Yet i have no rpms on my gauge. im not sure if i have the jumpers set up properly i have JP4 on and JP2 to hall as i believe the crank sensor for mx5 is a hall sensor. any help appreciated please.
Yet i have no rpms on my gauge. im not sure if i have the jumpers set up properly i have JP4 on and JP2 to hall as i believe the crank sensor for mx5 is a hall sensor. any help appreciated please.