Any questions you have before you begin buying, building and installing.
By HSPRZEPA
#68455
My goal is to run a k24a2 without a chassis, using a makeshift fuel cell (acura TSX fuel pump bolted into a 5 gallon bucket), rsx type s harness, 2004 accord run by cable throttle body, TSX fuse box, battery, and a speeduino. My goal is to simply run the engine (even in limp mode) like in this video:

https://youtu.be/jG8M-rGe1To?si=WuO7BWp86czQpatI

I would prefer to do this myself instead of purchasing a pnp.

I'm looking into purchasing the Speeduino v0.4.3, an arduino, and an aftermarket rsx type s harness. I'm looking to pin the harness to the speeduino per this video (Note: the video shows a k24a4 not a k24a2):

https://youtu.be/DWRU9ic7ElM?si=RJlKsprp0gNtqJxf

The forums show old posts of the k series decoder being "finished soon", but I don't see anything in the speeduino manual.

Can somebody help me out? Any tips? Thanks!
By dazq
#68456
Be careful in the use of "k series" as this applies to both honda and rover engine types.
There are many running honda engines on here , I wonder if some of the references you found were to the development of the rover pattern which was far more complex.
By HSPRZEPA
#68467
Good point! I guess for starters, is there a trigger pattern for the Honda/acura k24 platform? I don’t see one in the manual or options in tuner studio. There is one for Honda d17 however.
SPEEDUINO installed

What is ATV? Your local govt test scheme? I think […]

Hello All, Looking at ordering parts. Digikey hav[…]

Thanks for the reply and explication. The ha[…]

BMW E23 M30B28

I have used 14point7 products successfully. Note […]

Still can't find what you're looking for?