Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
Any questions you have before you begin buying, building and installing.
By BasilF
#58699
I.ve got the sensor shown on a pair of Honda CBR500R Throttle bodies.
TPS1.jpg
TPS1.jpg (3.88 MiB) Viewed 441 times
TPS2.jpg
TPS2.jpg (3.66 MiB) Viewed 441 times
Does anyone know where I can get a 5 pin connector for this without buying a Honda loom?

Also I'm trying to work out the pins. I've seen https://speeduino.com/forum/viewtopic.p ... tps#p21709 so I'm pretty sure there is a 5v serving the TPS and MAP, an earth serving all three and outputs from all three giving 5 pins. I can probably work it out but the common 5v complicates things a bit so if anyone has the data it would be a great help.
Cylinder Wiring question

I have a 4 cylinder Nissan engine with a firing or[…]

Hi, I'm looking at using a Speeduino for a small […]

PCB for BMW m52 engine

You can extend the data curve to find the correct[…]

These are hard to remember.

Still can't find what you're looking for?