[JarnoPettersson]

Hi,

I am a newbie in this field, but tinkering has always been my choise poison.

I have been riding my 1999 HD Heritage Softail for years and 2 years ago I swapped the cam from stock to S&S502 and the CV Keihin carb has been adjusted in dyne, but it was tricky and we had to use lower setting instead of full power for it to be usable on the street.

Now my goal is to install Speeduino engine management and dash with Raspberry Pi with 10 inch resistive touchscreen.

I don´t know if I am just pushing my luck, but I am searching for knowledge for this build.

Few years back I installed batwing for more riding comfort and it can house all the equipment.

As for throttle body, I am going to use Harleys intake manifold and maybe injectors and position sensor, if they are compatible.

At this early point I would like to hear has anyone ever done anything similar?

Only thing I got from searching harley was that it uses a timing cup similar to BMW K100, but that searc came up empty.

[LAV1000]

First you need to figure out a decent way to get crank pulses.....
Some Harley people are used to to buy the right bolt on stuf...
For this I think it is going to more a fabrication item.
No clou on the dash.