Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
Any questions you have before you begin buying, building and installing.
By MattyH
#57366
Hey all,

Question on how I have allocated the pins from factory harness to the UA4C pins. Will it run with what I have allocated?

The highlighted yellow are what I am confused about however I can't rule out anything else being incorrect.

Highlighted green is the pins used up.

Feedback or recommendations are welcomed.
Attachments
(10.12 KiB) Downloaded 20 times
#57509
what ecu is the stock one in the mx5, you have to be careful as the ac fan out may be a 12v signal which you have connected to a speedy out, its to signal ecu to idle up with the load, also same with ac comp and switch pins may be 12v
also idle valve power needs a fused 12v feed as speedy only grounds the idle pins and idle 2 is used for 3 wire, we only have 2.
clutch switch wire to launch.
Dirty cheap fuel-only Ducati build

When I search for ST2 FPRs I get this thing that a[…]

Apologies for the tardy response. Been busy with o[…]

ca20e help

the orange screw terminal, in the bottom left corn[…]

They are functionally identical to the larger boar[…]

Still can't find what you're looking for?