[ecular]

Test bench simulator issue.
Now running and spark working, but no injection happening.
Fuel table shows fuel load changing when MAP changes.

I wonder what is missing?

[dazq]

Post your log and tune will help us.

But you could look at your TPS ,see it is not in flood clear

[ecular]

Tune is too big to fit on post.

Flood was off.
What I was examining was that Reset Lock OFF was on red.
I wonder if that has something to do with this?
How can I change that?
I cut the reset-en track on arduino, but that had no effect.

I was trying to modify arduino for diasbling uart reset as described in reset control, but those instructions I found were ambiguous.
Shoud I connect a wire from control port to 16u2 reset or 2560 reset?
I could not find any diagram showing that actually?

[LPG2CV]

post your tune (.msq) you can zip it if you have issues

[ecular]

tune attached.

[LPG2CV]

your not getting any fuel, because in the VE table the MAP value starts at 100 kpa ???

[ecular]

Well, I have up to 140 kpa available, but still nothing.
I changed even VE table to strot from 90 kpa, still no injection.

[jonbill]

It needs to start at say 16. your MAP will be 30-40 at idle

[ecular]

Thanks, now it's getting better , but still no pulse with or duty cycle nothing happening on injectorsd.

[jonbill]

It looks like you didn't start with the base tune - many tables are blank - e.g. injector open time, IAT correction, cranking enrichment etc etc. They all mean that you're going to have zero fuel.
I'd suggest export the tables you've done work on (VE, spark?) and then load the default tune and copy those tables back in.