- Thu May 13, 2021 2:37 am
#50284
I have a Spitfire that will be fuel injected using BMW motorcycle throttle bodies. I'm using a UA4C Speeduino to control everything. It has been running twin Weber DCOE carbs and MegaJolt wasted spark ignition that uses a ford EDIS module.
So my plan is to get it running on spark only at first (just as it was with the MegaJolt) Then when that was dialed in I would add the fuel side.
The plan was to use the ford coilpack consisting of a pair of dumb coils. I have a Bosch 2 channel 200 ignitor wired in between the UA4c and the coils and I can't get a spark. I've triple checked my wiring and tried every possibility in TunerStudio. Is it possible that my coilpack and ignitor are not compatible? My VR crank sensor is putting out about 5mv when cranking the engine and I believe it is connected to the UA4C correctly. I am going to borrow an oscilloscope this weekend to confirm that the VR sensor is working.
Any advice on how to configure TunerStudio to get this combination working?
Also the 4 Bar MAP sensor on the UA4C isn't included in the list of common sensors in TunerStudio. Does anyone know the values to enter in order to configure it myself?
Thanks
So my plan is to get it running on spark only at first (just as it was with the MegaJolt) Then when that was dialed in I would add the fuel side.
The plan was to use the ford coilpack consisting of a pair of dumb coils. I have a Bosch 2 channel 200 ignitor wired in between the UA4c and the coils and I can't get a spark. I've triple checked my wiring and tried every possibility in TunerStudio. Is it possible that my coilpack and ignitor are not compatible? My VR crank sensor is putting out about 5mv when cranking the engine and I believe it is connected to the UA4C correctly. I am going to borrow an oscilloscope this weekend to confirm that the VR sensor is working.
Any advice on how to configure TunerStudio to get this combination working?
Also the 4 Bar MAP sensor on the UA4C isn't included in the list of common sensors in TunerStudio. Does anyone know the values to enter in order to configure it myself?
Thanks