- Sun Jan 24, 2021 6:55 am
#47792
I have an EP91 Starlet which i'd like to get a Speeduino going on, i have had a look at the wiki but that left me with a few more questions than answers.
I'm not asking for someone to give me wiring instructions or anything like that. But i have some more general questions, specific info for a 4E would be great though.
My first question is am i likely to have issues just wiring the Speeduino in to existing wiring (just replacing the stock ECU). Are there any sensors i may need to add or check on my current engine if they will work before i wire it up?
I assume a 0.4 board would be suitable for this engine in N/A or Turbo form?
I'm a bit confused about the crank angle / camshaft sensor, this i suppose is more a mechanical question but i will need to know what my engine has (not 100% sure where to look) and use that. Since this is specific to the engine any advice that would help me get started figuring this one out would be great.
Can a base map be setup with the car still using a narrow band O2 sensor?
I'm sure i will have many more questions but i don't want to go overboard just yet. Essentially just need a leg up to get started, thanks in advance.
I'm not asking for someone to give me wiring instructions or anything like that. But i have some more general questions, specific info for a 4E would be great though.
My first question is am i likely to have issues just wiring the Speeduino in to existing wiring (just replacing the stock ECU). Are there any sensors i may need to add or check on my current engine if they will work before i wire it up?
I assume a 0.4 board would be suitable for this engine in N/A or Turbo form?
I'm a bit confused about the crank angle / camshaft sensor, this i suppose is more a mechanical question but i will need to know what my engine has (not 100% sure where to look) and use that. Since this is specific to the engine any advice that would help me get started figuring this one out would be great.
Can a base map be setup with the car still using a narrow band O2 sensor?
I'm sure i will have many more questions but i don't want to go overboard just yet. Essentially just need a leg up to get started, thanks in advance.