Any questions you have before you begin buying, building and installing.
User avatar
By TurboPirate
#45648
Hello gang, thanks to weather problems I lost the Daewoo, now I am gonna convert a Mazda B2200 1990 from carb to EFI, but want to control fuel only, I want to keep the factory ignition with vacuum advance, do I need an specific software for this? Or do I have to go Crank Trigger? Thanks in advance
User avatar
By TurboPirate
#45752
Hello and thank you for your time, I loaded the latest software on the 2560 R3, but if you know a software that can work, just read the RPM signal from the single coil good, if you know it will be easier to convert to crank trigger I have everything from an old Ford Escort 4 cylinder trigger wheel and sensor...................................TP
User avatar
By TurboPirate
#45812
I read the wiki, just want to know if I can with that MAZDA but I think I will go the with Crank trigger...........................Thanks for your time.............................................TP
User avatar
By TurboPirate
#62203
Thank you, it is done with distributor mode.......what was a pita was to find the F.I. intake manifold from Mazda 626 to avoid building an intake manifold, almost 3 years but done....
Running a k24a2 w/o a chassis

Good point! I guess for starters, is there a trigg[…]

Have you tried Missing Tooth (crank) as a 2-1 wh[…]

BMW E23 M30B28

The issue got worse recently. From the logs I can […]

Cool. 8-) Yes, it's actually simple to do basic[…]

Still can't find what you're looking for?