- Wed Jun 29, 2022 4:16 am
#57568
As part of messing about with my Speedy NO2C project, i built the Ardustim 1.4 board, Nano V3.0 and running Josh's Ardustim 0.0.4.exe, uploaded firmware version 202108. Other then the known RPM sweep issue, it works well. Have selected 24-1 wheel only. Connected to a NO2C and using TunerStudio MS lite 3.1.06.
I have seen other posts noting a mismatch between the RPMs displayed in Ardustim and TS, but these are single digit errors. What I am seeing is TS 1500 / Ardu 1300, TS 2500 / Ardu 2000, TS 3500 / Ardu 2800 and so on up the scale eg TS7500/ Ardu 6000.
Ardustim leds for inj 1 and spark 1 (project is a single cylinder motorcycle) are strobing as expected, FP light on solid. Scoping inj1 and spark1 looks what I would expect (within the limits of the scope - Hantek 6022 / Open Hantek)
The other gauges in TS are all working and displays alter as the pots on the Ardu board are turned. MAP gauge changes when vac applied to the tube.
No tuning adjustment changes have been made yet, this is mainly about seeing if the NO2C I assembled is working.
Is there anything I should be doing to get the rev readings closer? Should I even care?
Thanks in advance
I have seen other posts noting a mismatch between the RPMs displayed in Ardustim and TS, but these are single digit errors. What I am seeing is TS 1500 / Ardu 1300, TS 2500 / Ardu 2000, TS 3500 / Ardu 2800 and so on up the scale eg TS7500/ Ardu 6000.
Ardustim leds for inj 1 and spark 1 (project is a single cylinder motorcycle) are strobing as expected, FP light on solid. Scoping inj1 and spark1 looks what I would expect (within the limits of the scope - Hantek 6022 / Open Hantek)
The other gauges in TS are all working and displays alter as the pots on the Ardu board are turned. MAP gauge changes when vac applied to the tube.
No tuning adjustment changes have been made yet, this is mainly about seeing if the NO2C I assembled is working.
Is there anything I should be doing to get the rev readings closer? Should I even care?
Thanks in advance