Anything not specifically related to the Speeduino hardware. Eg sensors, bluetooth, displays etc
User avatar
By pggood
#55858
Hi Im New to this enviroment and the Teensy 3.5 and 4.1 have the CAN bus on different pins. Im looking at building on to control a ford modular v8 (5.4 Falcon) that has coil per spark ignition. Would prefer not to use waisted spark if I can avoid it and that is the reason to look at the Teensy version. The Teensy 3.5 is currently out of stock so Im looking at building one around the 4.1 however it is diffucult to determine what pins if any are associated with CAN communication the 4.1 in the firmware or even if the firmware supports CAN on a 4.1 at all. Any guidance would be appreciated
By dazq
#55862
The support for can on the 4.1 is untested, but the firmware does enable the primary pins for use as shown on the card from pjrc.
Running a k24a2 w/o a chassis

Good point! I guess for starters, is there a trigg[…]

Have you tried Missing Tooth (crank) as a 2-1 wh[…]

BMW E23 M30B28

The issue got worse recently. From the logs I can […]

Cool. 8-) Yes, it's actually simple to do basic[…]

Still can't find what you're looking for?