- Wed Jan 06, 2021 6:38 pm
#47465
Hi all!
I'll be making a loom for my UA4C soon. I've looked at the official Amphenol crimp tool but the cost is difficult to justify for a one off install.
I'm thinking if I purchase the crimp tool, I could make custom pigtail looms for other UA4C users to recoup some of the costs.
E.g. I could crimp to your required wire spec and lengths rather than you buying a 300mm pigtail loom and splicing into it.
Alternatively, you could send me a load of connector pigtails stripped from a scrap vehicle and I can cut them to length and crimp Amphenol terminals on the end.
I think we could all benefit from this - all of our installs will be neater and more reliable without each user having to purchase a crimp tool that they may only use once.
Is there much interest in this idea or is anyone already offering this service?
I'll be making a loom for my UA4C soon. I've looked at the official Amphenol crimp tool but the cost is difficult to justify for a one off install.
I'm thinking if I purchase the crimp tool, I could make custom pigtail looms for other UA4C users to recoup some of the costs.
E.g. I could crimp to your required wire spec and lengths rather than you buying a 300mm pigtail loom and splicing into it.
Alternatively, you could send me a load of connector pigtails stripped from a scrap vehicle and I can cut them to length and crimp Amphenol terminals on the end.
I think we could all benefit from this - all of our installs will be neater and more reliable without each user having to purchase a crimp tool that they may only use once.
Is there much interest in this idea or is anyone already offering this service?