Page 2 of 2

Re: Wifi working - but the data isn't accepted by tunerstudio, real dash, msdriod. What is wrong?

PostPosted:Fri Oct 09, 2020 1:24 pm
by miker
Thanks Ric. I'll look to get the wiki updated so others don't make this mistake.

So as we think real dash should work - do we have any idea why it isnt working? What can i do to investigate / troubleshoot?

Updating the pins to D0/D1 and the wifi works with tuner studio so we know the hardware / software setup is correct. Thanks again.

Re: Wifi working - but the data isn't accepted by tunerstudio, real dash, msdriod. What is wrong?

PostPosted:Fri Oct 09, 2020 2:02 pm
by dazq
Although the "data" is the same as what tunerstudio has access too, the protocol is not.
Unfortunately we have to abide by tunerstudio developers for the protocol to communicate with TS , not the other way :-( .
Additionally TS expects the configuration parameters to be sent to it upon connection ,( only after that will it then begin to display realtime information) something which serial3 neither can do not needs to do as no dash or external device needs that information .

Re: Wifi working - but the data isn't accepted by tunerstudio, real dash, msdriod. What is wrong?

PostPosted:Fri Oct 09, 2020 4:26 pm
by ric355
miker wrote:
Fri Oct 09, 2020 1:24 pm
Thanks Ric. I'll look to get the wiki updated so others don't make this mistake.

So as we think real dash should work - do we have any idea why it isnt working? What can i do to investigate / troubleshoot?

Updating the pins to D0/D1 and the wifi works with tuner studio so we know the hardware / software setup is correct. Thanks again.
I think the realdash developer is on this forum - have a search for a thread about it and I'm sure you'll find him.

Re: Wifi working - but the data isn't accepted by tunerstudio, real dash, msdriod. What is wrong?

PostPosted:Fri Oct 09, 2020 5:00 pm
by miker
This started out as a conversation on faceache, I'm sure he was in the thread so I'll hopefully catch him either there or here.

Interestingly, realdash also works on D0/D1.

Re: Wifi working - but the data isn't accepted by tunerstudio, real dash, msdriod. What is wrong?

PostPosted:Fri Oct 09, 2020 5:01 pm
by Eric H
I had this discussion a couple of months ago.
Serial3 is not the same as the USB. It was not designed to be the same.
It does not support the full data set that the USB gets.
This is something I plan on addressing the the future when I get some time.