Anything not specifically related to the Speeduino hardware. Eg sensors, bluetooth, displays etc
By Lawzracn442
#45306
Hi guys and gals. I’m finally in the starting/tuning stage on my big block chevy MPI setup with a 0.4.3c board, fuel only. I have found a bad MOSFET for INJ3 that is stuck on constantly. The other 3 outputs are working fine. I am just curious how common is this to happen? I have checked my harness to verify nothing is shorted.
This seems like a bit of a big deal as this one failed on and was dumping fuel constantly when the Speeduino was powered up. Just looking for thoughts on previous experience. Thank you in advance!

I uploaded logs and last tune and dyno plots look[…]

you could set 'skip revolutions' to 3, then it wou[…]

Hi, I am trying to assign Signed values to the x-a[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Still can't find what you're looking for?