- Mon Oct 29, 2018 8:41 am
#29841
Hello,
after the Speeduino works stable since a few thousend kilometers I try to add a selfmade quickshifter based on an arduino nano and the code of an Internetvideo "Kazeshifter"
My differences are that I built a real Sensor for the Gear lever instead of this brake light switch and wanted to replace the relais because of the delay of switching (or is it not a problem?)
The Problem I have is that I can´t find the right module for this job. I tried it with an opto coupler SFH610A wich connects VR+ and VR- of the speeduino for round about 70ms. But there is no cut in Ignition. If I conenct the both PINS manually, it works like I imagine.
The next test was with a LED connected to 5v from arduino 5v PIN to the collector and Ground to the Ermitter. That works, the LED blinks when I try to shift up.
has anyone an idea?
after the Speeduino works stable since a few thousend kilometers I try to add a selfmade quickshifter based on an arduino nano and the code of an Internetvideo "Kazeshifter"
My differences are that I built a real Sensor for the Gear lever instead of this brake light switch and wanted to replace the relais because of the delay of switching (or is it not a problem?)
The Problem I have is that I can´t find the right module for this job. I tried it with an opto coupler SFH610A wich connects VR+ and VR- of the speeduino for round about 70ms. But there is no cut in Ignition. If I conenct the both PINS manually, it works like I imagine.
The next test was with a LED connected to 5v from arduino 5v PIN to the collector and Ground to the Ermitter. That works, the LED blinks when I try to shift up.
has anyone an idea?