Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
Anything not specifically related to the Speeduino hardware. Eg sensors, bluetooth, displays etc
#45748
Thanks Ric. I'll look to get the wiki updated so others don't make this mistake.

So as we think real dash should work - do we have any idea why it isnt working? What can i do to investigate / troubleshoot?

Updating the pins to D0/D1 and the wifi works with tuner studio so we know the hardware / software setup is correct. Thanks again.
#45750
Although the "data" is the same as what tunerstudio has access too, the protocol is not.
Unfortunately we have to abide by tunerstudio developers for the protocol to communicate with TS , not the other way :-( .
Additionally TS expects the configuration parameters to be sent to it upon connection ,( only after that will it then begin to display realtime information) something which serial3 neither can do not needs to do as no dash or external device needs that information .
#45754
miker wrote:
Fri Oct 09, 2020 1:24 pm
Thanks Ric. I'll look to get the wiki updated so others don't make this mistake.

So as we think real dash should work - do we have any idea why it isnt working? What can i do to investigate / troubleshoot?

Updating the pins to D0/D1 and the wifi works with tuner studio so we know the hardware / software setup is correct. Thanks again.
I think the realdash developer is on this forum - have a search for a thread about it and I'm sure you'll find him.
Problem with fuel pump outlet

Hello again. I think I found the problem, it is t[…]

Here are wiring diagrams for three Ch(203 or 209) […]

Ok, you can't bypass the 5v regulator, it must hav[…]

Modified 3 cylinder

You should read up on how OEM go about shutting do[…]

Still can't find what you're looking for?