Thanks a lot! So basically i need to make sensor signal into VR1+, sensor supply from +5v and sensor ground into ecu? it sounds good but why do i have +5v at vr1+? is this correct?
jumpers configiratuion is correct with official pazi schematics, but it makes the +5v at VR1+, im confused idk is this correctjonbill wrote: ↑Tue Jul 27, 2021 9:50 amYes, that sounds right.
I don't know whether you should or shouldn't be able to read +5v on VR1+ - do you have the jumpers on the board correct for hall?
on the 0.4.3 boards there are jumpers to select direct or signal conditioner (hall/ vr) and whether to enable a pullup for the hall. (which suggests maybe it should be pulled up to 5v, but I don't understand electronics well enough to be sure!)
Thanks mate! So i will make VR1+ as signal, some +5v to supply sensor and sensor ground to ecu and it should work. I will let you know if it worked. Thanks a lot guys!
Can't help with IAC. Your intake runner. Use the […]
After weeks of search. here is the result, it is[…]
Some just pull the linkage a little, so all butter[…]
Just a hint for your engine: The latest engine bui[…]