[josefodunga]

HI, I just installed a Seawolf VB2 on a Renault Clio RSi 1997.
I have doubled checked the pinouts on the board but when I go to tuner studio to check everything the MAP readout changes when I accelerate. No other readouts change when I accelerate. I also tried changing the pressure (sucking and putting some comrpessed air on the hose) on the MAP sensor to see if something else changed but I couldn't see anything else changing its readout.
I was wondering if I had done something wrong or what the deal is.
Firmware is 202008. I checked and TPS pin goes to Analog 03 in the Arduino Mega Board.

Thanks and all help appreciated.

[jonbill]

Is your MAP plumbed to your manifold? if so, the MAP reading should change when you accelerate.

[theonewithin]

You need to post your tune and a log during issue so we can actually see what is happening

Would all be guesses until then.

[NickZ]

Select the correct board in the Engine constants/Board Layout