[Brainiac]

My project is taking place nowadays as an inspired idea by other designers here.

Please advise me for any mistakes as i'm at the schematic phase.

Thanks.

Saxo Schematic rev1.0.png (138.99 KiB) Viewed 5690 times

[alex-84]

what is the use of the diode on the serial link with the hc06? oriented like this it should block the signal

[Dagaz_Psi]

I run the diod the same way on my board and it works fine. The use for the diod is so you dont have to remove the bluetoth module when you put in the usbcabel for it to connect to tunerstudio.

[Jama]

I replied to the designer elsewhere but will post here for anyone else planning on doing the same.
For reference, I'm the designer if the CORE4 module.

The Bluetooth diode is not required on the daughterboard as this (and the bypass) are onboard on the CORE4 module.
The reset circuit is not needed as that again is all handled on the module.
There is input protection on all of the normal inputs (TPS, CLT, IAT, MAP....)
D33-D36 are directly wired to the atmega pins, these are intended for driving extra outputs such as hi-side drivers, care should be taken when using these pins.

James

[Brainiac]

After a long time i'm back to the project.
I was ready to do some tests but my mistake was that the connector holes are smaller than the connector probes.

Here is the PCB sitting in the case:



Waiting for the corrected design to arrive.

[AlexanderBurgers]

This looks so much better than my half-built ECU. Any chance we can get the board files?

[Tony Evo]

On these engines the map is superfluous, it is already present on the intake manifold.