[NicoEFI]

First test power on.
it s OK.
Tunerstudio can read battery voltage but i need to calibrate the reading

20200101_175126.png (1.76 MiB) Viewed 8723 times

[NicoEFI]

soldering finished

20200105_184008.jpg (4.85 MiB) Viewed 8653 times

[skotik]

Hey . How do the tests go?

[NicoEFI]

I solved somes design problem and redesign a pcb.
Now it works well on the simulator.

I also modified the code to have a variable launch control via a potentiometer and between a low and high limit.
This allows, if the road is wet or dirty, to modify the launch control for not skate.

This is my 1st decode modification and it works,

I am going to modify launch soft rev limit also with a step retractable from launch Hard rev limit.
For example: if the step is 200 and if the launch Hard rev is 7000 then the Launch Soft rev is 6800. So regardless of the value of Launch Hard rev the delta with Launch soft rev will always be the same.

launch variable.PNG (46.46 KiB) Viewed 8036 times

[NicoEFI]

File can find on Github https://github.com/NicoEFI/Speeduino-MicroEFI-V2-GDRace

[Pyro329]

Hi.

Do you have boards for sale? I need one, I only need it for ignition, if you have for sale which one is the most economical.

[NicoEFI]

HI
I am trying for the 1st time to use my ECU.
I need help
I don't have an injection. RPM, sparks are ok.
If I use the injector hardware test it's ok, the injectors are ordered. But under starter the injectors are not controlled.
I only use 2 injector controls for 4 injectors. 1 and 4 are paired, 2 and 3 are paired.

An idea of the problem ?

setting.PNG (44.71 KiB) Viewed 4864 times

[pazi88]

Your Req. fuel is zero.

[NicoEFI]

Your Req. fuel is zero.

MANY THANKS . I'm very bad not to have seen this
Engine RUN

[dvjcodec]

Can U share footprint for connector and board? I have same enclosure and want to use to my other projects.