Hello Pazi88! Firstly, thanks for all the shared resource you have added to my projects!
So I've recreated this project for myself.
I'm using vs. rev2.1
I have *I think* completed the fabrication.
https://photos.app.goo.gl/uBMgHwL8WSaXj4zn8
A few questions that don't seem to have clear answers for me:
1) Where is the sequential firmware? The links show no longer available. I believe that is because it is merged with speeduino firmware?
2) I have only started bench testing. When I run ardustim, I am able to create an RPM that get's the ignition firing, but none of the injectors. I have both the Speedy and stim running through the laptop, do I need a 12V battery, or can the laptop sufficiently fire the injector? I have verified that my ignition drivers appear like the left in the picture in #37053 post. I have also repeated this procedure using Hardware Testing feature in TS. I have also manually changed and updated globals.h. Can you run through some debug procedures to find me find my problem?
3) I am unclear on jumper configuration for ALL JP1-5 & Cam Sensor jumper. I intend the stock crank sensor, and M52TU cam sensor and sequential. Can you possibly add a chart to the M52 instruction doc that shows how exactly to configure the JP1-JP5? Should I be following Speedy manual for this, or do you have a different configuration for these jumpers? (This may be contributing to problem #2.)
4) I am adding a 3.5" tft lcd through serail3 using the plug TX RX connections and it seems to be working well. Would you like information about my setup to add detail for those wanting a separate interface?
https://photos.app.goo.gl/MzDRNZwmgv1HM1UJ8