One piece will ship to Turkey for tests on vehicle.
One piece I will test myself.
One piece will be connected to 2500HP engine (pulling tractor) / "The Bear" pulling team.
Mr_Hypnotic wrote: ↑Fri May 31, 2019 1:03 pm That is exciting!Most would use hot air. With so many parts; some would also order a stencil to apply the solder paste if hand-soldering with air (example: https://www.oshstencils.com/). Other common methods such as toaster ovens or hot plates can work well, but usually take a couple tries to dial-in; so if doing one or very few boards, air tends to be the go-to. Once set-up and familiar with SMD/SMT, it is as-easy or easier than through-hole stuff, except for perhaps a few of the really small or fine-pin parts. Still very do-able at home.
All those SMD parts! How do you solder those tiny parts?
dvjcodec wrote: ↑Sat Jun 08, 2019 6:15 pm Damn, sorry for my mistake I will fix in free time. Thank you for sharing news from tests. I have a very busy month, so tests of my board unfinished yet Need to finish 2 cars for customers, then find time for my own cars.
Ryan, is latest Speeduino firmware? Did U made some changes to run all in and outs?
https://github.com/noisymime/speeduino/ ... master.zip,and i changed code to fit pin mapping
For an absolutely basic fuel-only install, you can[…]
I've never heard of that problem - realdash only r[…]
In my opinion the easiest way is to just leave out[…]
nice first of all, i read all that crap months a[…]
Still can't find what you're looking for?