For discussion of Speeduino compatible boards designed / built by other members of the forum and for guidance around making such a board
#38795
Did you find the reason of the wrong voltage reading ?

And Dvjcodec, about the 10k pull-down resistors on each signal of 4504, did you update you schematic ? Cause I can already see a pull-down resistor on each mosfet, like R3 for Injector 1.
#39224
Finaly I finished fixed pcb for this ECU.
Fixes and updates:
- add 10K pull-down resistors
- Teensy 3.5 internal pad footprint fixed
- add solder-jumper to choose internal or external Map Sensor
Attachments
1.jpg
1.jpg (876.86 KiB) Viewed 13130 times
Last edited by dvjcodec on Sun Nov 24, 2019 7:14 pm, edited 1 time in total.
#39237
dvjcodec wrote: Sun Nov 24, 2019 7:14 pm
ryan_pajero-io wrote: Thu Aug 08, 2019 7:25 pm @dvjcodec

Have you tested the stepper motor?
it does not work on my board.
Please try to add 3v3 supply to ENAble

I have tried it, and the same result, there is a problem with the board. The stepper motor driver does not have 12V power at all. I gave the driver 12V power by jumper, but still can't work. I gave up
#39247
ryan_pajero-io wrote: Mon Nov 25, 2019 6:54 am
I have tried it, and the same result, there is a problem with the board. The stepper motor driver does not have 12V power at all. I gave the driver 12V power by jumper, but still can't work. I gave up
Yes, I a problem with board. Missing +12V connected to this point. Bug in schematic :/
Attachments
bug.jpg
bug.jpg (428.82 KiB) Viewed 13077 times
  • 1
  • 18
  • 19
  • 20
  • 21
  • 22
  • 25

Hi, I am trying to assign Signed values to the x-a[…]

Vr Conditioner Noise when cranking

New version 202305 don't fix the issue. Now after[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Hello, I bring news!! Let me tell you that after […]

Still can't find what you're looking for?