Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For discussion of Speeduino compatible boards designed / built by other members of the forum and for guidance around making such a board
By Julien Hilaire
#57490
Hi all,

what do you think about a speeduino's project in 2 pcb ?

I mean (based on an enclosure like DROPBEAR):
1 daughter pcb including all functions (8INJ, 8ING, IDLE, VVT, ...) + all filtering and modulation signals (CAM, CRANK, IAT, MAP, BARO, TPS, EGT, WBOx Ubat, IDLE) + AUTOMOTIVE CONNECTORS like DROPBEAR;
1 motherboard pcb with MCU but with standard numbers and peripherical position connectors to daughter board, 5v + BT or CAN signals, etc ...; with the ability to connect to various locations designed for MCU TEENSY3.X or TEENSY4.X or MEGA or ARDUINO PRO or STM32?

Isn't this a way to ensure that MCU availability won't be an issue?

Kind regards, Julien.
By LPG2CV
#57495
it requires 2 boards, so already more expensive to produce!

also, some are 5v and some are 3v and require amplification. :)

Not knocking it though :)
Sync loss on gsxr

Hi Good summer! I am still fighting this problem […]

My bad, happens on hybrid bikes. ST2 has an in tan[…]

Apologies for the tardy response. Been busy with o[…]

ca20e help

the orange screw terminal, in the bottom left corn[…]

Still can't find what you're looking for?