My initial question question might of been a bit vague.
I will try to make it more clear and if anyone has any info about the subject, than please feel free to share.
Looking for documentation for hooking up teensy 3.6 and/or teensy 4.1.
I'm guessing most of them are freely configurable but just to be on the safe side, it would be great to get some confirmation before i send the boards out for manufacture.
Are there dedicated/preferred pins for the following functions:
- crank trigger
- cam trigger
- injectors 1-8
- spark 1-8
- SPI and int/hold for TPIC8101 knock interface
- serial for communicating with the GIPO uC
- tacho signal
- fuel pump
- boost control
- PWM idle
- idle stepper (step/dir)
- Manifold air pressure
- Intake air temp
- throttle position sensor
- battery voltage
- barometric sensor
* Is the TPIC8101 knock interface over SPI already implemented?
* I remember reading 2-way communications over CAN not yet implemented so I'd have to use Serial to communicate to the the GIPO uC?