For any add-on boards such as VR conditioners, optos and OEM interface boards
By TechColab
#52546
This was approved by noisymime as suitable for the next official Speeduino VR board, some time before all VR boards were dropped from the main Speeduino repo.
Based on the usual previous designs & data sheet with the following notable points:
20x20mm with rounded corners and two mounting holes.
8-pin DIP header pin mounting/connection for Speeduino (& other) compatibility.
4-pin SIL pin header for breadboard / PCB edge mounting.
On-board SMT capacitor for optional PTH 5V regulator.
SMT resistors sized as per noisymime recommendation.
SMT components on only one side to minimise height for cheaper letter postage of minimally assembled PCB.
Optional power resistors as per datasheet.

https://github.com/TechColab/VR-Conditioner-MAX9926-reg

Hi, I am trying to assign Signed values to the x-a[…]

Vr Conditioner Noise when cranking

New version 202305 don't fix the issue. Now after[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Hello, I bring news!! Let me tell you that after […]

Still can't find what you're looking for?