Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any add-on boards such as VR conditioners, optos and OEM interface boards
By NickZ
#46397
I have just received version 2 of my 8 injector and 8 ignition engine simulator board.
new version
Engine simulator.
8 injector LEDs
8 Ignition LEDs
6 Output LEDs
Analog Pots : Coolant Temp, Air Temp, MAP, TPS, O2, AUX1 (Oil pressure?), AUX2 (Fuel pressure?)
Analog Pot : RPM speed
2 Input buttons to simulate Launch control etc
Easy Plug in Screw terminals.

Uses a Arduino nano and ardu-stim.
adjustable voltage output for testing trigger adapters
20201122_164003 copy.jpg
20201122_164003 copy.jpg (639.23 KiB) Viewed 212 times
20201122_165144-copy.gif
20201122_165144-copy.gif (3.61 MiB) Viewed 210 times
Last edited by NickZ on Sun Nov 22, 2020 7:13 am, edited 3 times in total.
Fuel load calculation

Starting to look at the injectors properly now tha[…]

Kawasaki Concours 2.0

Having second thoughts about cutting a hole in my […]

I finally think I have almost crossed another hurd[…]

Weird TPS+voltage problem

it could be corruption in the tune. Can I suggest[…]

Still can't find what you're looking for?