If a car doesn't use a stepper motor you could install this board on the DRV8825 headers and use the A, A2, and B1 as inputs.
I need some critic I am a noob its my firs time doing a board layout.
Thx for the input, (no pun intended) .dazq wrote: ↑Fri Oct 09, 2020 10:01 amI think you will need to also make a few code changes .
You should change the stepper pins for the board you are using to something else that are unused else when you try to use the inputs via auxin they may misbehave or not even work as there will be an assignment clash in the firmware.
Starting to look at the injectors properly now tha[…]
Having second thoughts about cutting a hole in my […]
I finally think I have almost crossed another hurd[…]
it could be corruption in the tune. Can I suggest[…]