For anything related to the 'official' Speeduino boards (Eg v0.3, v0.4 etc)
By Enriketo
#56209
Hello, I would like to know how I can modify the outputs that come by default on the 0.4 board to use the idle 2 mosfet and use a programmable output instead.
In TS it allows to change the vvt output, but I don't see the option to change the idle pin.
Thanks.

remember sensors need calibrating.. papa's ga[…]

SPEEDUINO installed

What is ATV? Your local govt test scheme? I think […]

Hello All, Looking at ordering parts. Digikey hav[…]

Thanks for the reply and explication. The ha[…]

Still can't find what you're looking for?