Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For anything related to the 'official' Speeduino boards (Eg v0.3, v0.4 etc)
User avatar
By FedericoVivori
#48624
Hello everyone
I am looking for information to adapt an iac stepper valve for idle control with a drv8825 driver. I have a speeduino v0.3.6 board
Could someone guide me to solve my problem?
Thanks
User avatar
By PSIG
#48649
FedericoVivori wrote:
Thu Feb 25, 2021 8:55 pm
I am looking for information to adapt an iac stepper valve for idle control with a drv8825 driver.
The DRV+ULN board is an adapter for DRV driver plus 4x 1A outputs. If you don't need the additional outputs, then the thread will give you the info you need to run just the DRV.

Yes, but voltage is limited one some, such as the […]

Second injector bank

there's a section on staged injection in the wik[…]

Injector dead time tester

That makes poor accuracy. You should check this[…]

EMI while cranking

Well in a last ditch effort and using scrap parts […]

Still can't find what you're looking for?